How to engraving a high resolution picture
Everyone wants to make the picture clearer, especially in laser engraving. Now you can simply make such a high […]
2019 the TroPro trade exhibition in Sydney, Australia
Thunder Laser is successfully exhibited at the 2019 the TroPro trade exhibition in Sydney, Australia from May […]
2019 Munich Photonics Exhibition
Thunder Laser is successfully exhibited at the 2019 Laser Photonics exhibition in Munich Germany from May 14th […]
2019 BITEC Exhibition in Bangkok, Thailand
Thunder Laser is successfully exhibited at the 2019 BITEC exhibition in Bangkok, Thailandfrom May 8th-11th BIT […]
2019 IAS Exhibition in Las Vegas from Apr 26th to 28th
Thunder Laser is successfully exhibited at the 2019 IAS exhibition in Las Vegas from Apr 26th to 28th The ISA […]
X-axis not moving at all
Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wir […]
Y-axis not moving at all
Here are the reasons: ● Rotary switch is turned on Note: The rotary-axis and y-axis can be switched, if the ro […]
Alarm message of LCD panel—Machine protected
LCD panel shows the following information: Our machine has sensors for door protection (front cover and laser […]
Alarm message of LCD panel—Water error
LCD panel shows the following information: Here are the reasons: ● Water chiller（water pump）is not turned on P […]
Alarm message of LCD panel—No enough extend space
LCD panel shows the following information: This problem only appears on engraving mode, it’s caused by t […]
