Why noisy while moving laser head front and back, how to adjust?
When you move laser head front and back, two couplings make a lot of noise. What is the cause of this? Both sides of transmission shaft are not aligned
The machine won’t turn on
Here are the reasons: ● Emergency Stop key is pressed If it’s pressed, please reset it, like below. ● The circuit breaker has tripped Locate on the lower right hand door panel (or back side door panel), please check if it’s in off position, and flip to on position, like below. Note: The machine before […]
Laser wood model cutting –Eiffel tower
laser cutting machine is widely used for cutting wood model; this time, Thunder laser will cut the Eiffel tower model! laser cutter file：Download Required items: Material:3mm plywood Laser head:standerd head Thunder laser used: Model: Nova 35laser cutter machine Laser Tube: 80 watt Setting: Processing Mode: cut Speed: 20mm/s Max power: 60% Min power: 70% The […]
SegMaker Exhibition Center of Thunder Laser System
In response to national call for independent innovation, to promote and cultivate more innovation projects and independent learning talent, Thunder Laser cooperate with Shenzhen SEG setting up an experience center to help more children develop their innovation and hands-on ability. Thanks SEG for providing the space and all staff there including Amy and Ben from […]
111
Frequently Asked Questions Buying guide About machine and parts About software About material application
How to calibrate the working table to level.
There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of the working table height of this side and calibrate the level in this way. […]
Some point of the same piece of materials can not be cut through, why
Some point of the same piece of materials cannot be cut through, why? This problem is mainly caused by following three reasons: 1. The cutting material is bent (not flat) or uneven density. 2. The working table is not level 3. Laser beam is not vertical after being focused by lens. 1. If the material […]
Thunder Laser is happy to make college-enterprise cooperation further
The Cooperation Between Thunder Laser and Guangdong Mechanical and Electrical Polytechnic（GMEP）for employment promotion Of College Students . Mr.Chen, CEO of Thunderlaser, has been always concerned about the development of his mother school after graduating from GMEP. And this year, in order to promote the employment of students, and also attract more talented young people to […]
Drive belts
Drive belts is an important part of getting the X,Y,Z axis moving, Low quality belts would age fast after high speed moving, this will result a bad impact on the cutting engraving effect. Thunder Laser cutting machine uses Kevlar drive belts. This belt is stable performance with long life, wearable and durable. Besides, it’s less […]
test
How to use your laser machine Machine Guiding Video 01 How to setup your nova laser cutter WATCH NOW ▷ 01 How to setup your nova laser cutter Machine Guiding Video 02 Functions of display panel WATCH NOW ▷ 02 Functions of display panel Machine Guiding Video 03 How to Use Motorized Table WATCH NOW […]
