CO2 laser cutting engraving machine processes material by heating the material with fast speed. It may cause the material burning when cutting some inflammable material like wood, leather and plastic. we must cool it by air assisting to reduce the possibility of be on fire. However accidents still may happen (once the air assist doesn’t work or the blowing air is shortage). In order to safety of machine processes, The Air-pressure control sensor recommended by Thunder Laser helps you to avoid these accidents.


Air-pressure control sensor


The Air-pressure control sensor made by Thunder Laser can measure the air pressure and indicate the air-pressure value in real time.it can set to measure even 0.01Mpa air pressure, it’s valid for both air pump and high pressure air compressor.

When it detects an Insufficient air pressure(once the air assist doesn’t work or the blowing air is shortage), the air-pressure control sensor will send signals to mainboard then alarm and stop the laser processes, and avoid the material burning without air assist to reduce the potential losses and risks.

サンダ一レ一ザ一Japan-お問い合わせ

お問合せ、有難うごさいます。
レ一ザ一の事や、機器の事、加工の事など、何でもご質問下さい。
折り返し、担当者から回答させて頂きます。
この機会を大切に出来ればと思います。





    サンダ一レ一ザ一Japan-お問い合わせ

    お問合せ、有難うごさいます。
    レ一ザ一の事や、機器の事、加工の事など、何でもご質問下さい。
    折り返し、担当者から回答させて頂きます。
    この機会を大切に出来ればと思います。