How to make a Deer headwear
Today I show you how to make a Deer headwear. Making Deer headwear is incredibly cheap & easy! There’s no need to spend a fortune on buying Deer headwear & Simply follow the step by step. Now is going to use a Thunder Laser system to make a Deer headwear. Let’s start to explore fun […]
Why the red dot pointer not being able to come out from the laser head.
Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, please open the lower left hand door panel, find the connector for the red dot and check if […]
Why the “Origin” button of LCD panel not working
Here are the reasons: ● The starting point is set to absolute coordinate in software. Locate on the bottom left corner, the option of “Position” please select to Current position. ● Origin setting is not proper on LCD panel. Open origin setting windows: Z/U button>>origin set+. Make sure the “Multiple Origins Enable” is not selected, […]
How do i replace the controller board
Firstly, turn off the whole machine power. Remove Old Part: Open the lower right hand door panel, find the main controller board, like below. Unplug all connectors on the controller board, then remove 4 screws located on each corner of the board. Install New Part: Screw 4 screws to fix the controller board and plug […]
Chiller alarms unusually
Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Keep the water level in the green area. ● Water circulation pipes are blocked or water pump break down Please connect a water […]
Air pump won’t work or no air assist when job starts
Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if air compressor can be turn on normally, like below: ● Wrong setting The air assist can be controlled […]
Exhaust fan cannot extract smoke or dust
Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if exhaust fan can be turn on normally, like below: ● Connect the fan inlet and outlet in […]
How to prepare your files for feeding into the laser program to cut
Scenario 1: If the vector has overlapped paths and it will be cut repeatedly. Solution： In RDworks, you can use “Delete overlap” tool to delete all overlapped paths, like below. Scenario 2: If you’d to make a rectangle at 30×30mm, however, it becomes 29.9×29.9mm when cut it through on material, because there’s a little […]
How to prepare your files for feeding into the laser program to engrave
Note: the laser machine can only burn into or through material. Also, the beam can only be made to follow straight or curved paths or to burn a grid of dots (a bitmap image). There is no way for the laser to represent color. ● Scanned Image Engraving The image is engraved by the laser […]
Cutting problem– Some point of the same piece of materials cannot be cut through
Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. Please fix the material with magnet and check if the working table are the same height, then calibrate according to the link below. […]
