Alarm message of LCD panel—Water error
LCD panel shows the following information: Here are the reasons: ● Water chiller（water pump）is not turned on Please turn on the water chiller before power on the machine, like below. ● Signal cable for water protection has no connection Please has signal cable connected, like below. ● Wiring problem Please check it according to […]
Alarm message of LCD panel—No enough extend space
LCD panel shows the following information: This problem only appears on engraving mode, it’s caused by the buffer distance is out of bound. For example, if you want to engrave a picture of 200×200mm, you move the laser head to the top left corner of the working table and press the “Origin” to set the […]
Alarm message of LCD panel—Frame/X/Y Slop over
LCD panel shows the following information: Here are the reasons: ● The size of the graphic is larger than the working area of the machine If your laser cutter’s working area is 600×400mm, but you want to cut a graphic which larger than 600×400mm, this warn appears. Since the laser is not able to work […]
Why noisy while moving laser head front and back, how to adjust?
When you move laser head front and back, two couplings make a lot of noise. What is the cause of this? Both sides of transmission shaft are not aligned
The machine won’t turn on
Here are the reasons: ● Emergency Stop key is pressed If it’s pressed, please reset it, like below. ● The circuit breaker has tripped Locate on the lower right hand door panel (or back side door panel), please check if it’s in off position, and flip to on position, like below. Note: The machine before […]
